新闻资讯
网站首页 > 新闻资讯 >

安装操作站报警如何判断?还需要进行哪些操作?

2020-10-28 10:50:29 来源:http://www.sdjkyqyb.com/ 53

操作站报警如何判断?
How to judge the alarm of operation station?
通常情况下,引起操作站故障的原因主要有两类:硬件故障和软件故障。下面分别介绍各种故障原因及处理方法。如果死机重启后无法进入操作系统界面,我们先听计算机启动时的提示音,按提示音初步判断故障所在,并先予以解决。如果提示音正常而无法进入windows界面,则应是windows文件有错误,需要重新安装操作系统。
In general, there are two main causes of the operation station failure: hardware failure and software failure. The following describes the causes of various failures and treatment methods. If you can't enter the interface of the operating system after the crash and restart, we first listen to the prompt tone when the computer starts, and then preliminarily judge the fault according to the prompt tone, and solve the problem first. If the prompt tone is normal and the windows interface cannot be accessed, the windows file is wrong and the operating system needs to be re installed.
     浙大中控
windows文件错误的产生可能是硬盘有坏磁道引起,需要先用windows98的启动盘启动后,在命令提示符下输入scandisk c:对硬盘的主分区进行扫描,确认硬盘没有故障的情况后,对操作系统重新进行安装;如果硬盘有故障,建议更换硬盘再重新安装windows操作系统。如果死机重启后可以进入操作系统界面,但间隔一段时间后,又会重新死机则需要分析软硬件的其它可能性。
Windows file errors may be caused by bad tracks in the hard disk. You need to start with Windows 98 boot disk, and then enter ScanDisk C at the command prompt to scan the main partition of the hard disk. After confirming that the hard disk is not faulty, the operating system is reinstalled. If the hard disk fails, it is recommended to replace the hard disk and then re install the windows operating system. If you can enter the operating system interface after a crash and restart, but it will crash again after a period of time, then you need to analyze other possibilities of software and hardware.
安装完操作系统后还需要进行哪些操作?
What else do you need to do after installing the operating system?
A:1、安装主板、显卡、声卡、网卡等驱动
A: 1. Install the main board, graphics card, sound card, network card and other drivers
2、安装组态软件
2. Install configuration software
3、进行IP地址设置(根据网卡数量及操作站地址设置)
3. Set IP address (according to the number of network cards and the address of operation station)
4、关闭网卡流控制
4. Turn off NIC flow control
5、连接网络,进行组态或监控运行
5. Connect the network for configuration or monitoring operation
以上是关于浙大中控操作站报警如何判断的介绍,希望对大家有所帮助,如想了解更多内容欢迎点击http://www.sdjkyqyb.com网站。
The above is about Zhejiang University central control operation station alarm how to judge, hope to help you, if you want to know more content, welcome to click http://www.sdjkyqyb.com Website.
产品推荐
新闻推荐