新闻资讯
网站首页 > 新闻资讯 >

中控DCS卡件系统的使用有什么注意事项

2022-09-17 16:44:37 来源:http://www.sdjkyqyb.com/ 53

DCS系统是由系统软、硬件,操作台盘及现场仪表组成的。系统中任一环节出现问题就会导致后续的异常使用,下面浙大中控DCS卡件厂家为您讲讲中控DCS卡件系统的使用有什么注意事项。
DCS system is composed of system software, hardware, console and field instruments. Any problem in any part of the system will lead to subsequent abnormal use. Now, the manufacturer of the DCS card system of Zhejiang University Central Control will tell you about the precautions for the use of the DCS card system.
当系统出现停电时,应立即将系统中投入自动控制的回路切到手动。当供电正常时,首先检查系统运行及系统数据是否正常,如果有异常现象,重新下传组态,并检查核对系统参数。一切正常后方可再次投入自动。(参数表参见相关资料)
In case of power failure of the system, switch the automatic control loop in the system to manual mode immediately. When the power supply is normal, first check whether the system operation and system data are normal. If there are abnormal phenomena, download the configuration again, and check the system parameters. Automatic operation can be started again after everything is normal. (See relevant data for parameter list)
统启动运行上电顺序:UPS、控制站、显示器、操作站计算机。
Power on sequence of unified startup operation: UPS, control station, display, operation station computer.
停机次序:控制站计算机、显示器、控制站、UPS。
Shutdown sequence: control station computer, display, control station, UPS.
操作员口令维护:每台操作站上的操作员口令之间无任何关系,须单独建立。口令是保证系统安全正常运行的前提,须严格执行。
Operator password maintenance: there is no relationship between operator passwords on each operation station, which must be established separately. Password is the premise to ensure the safe and normal operation of the system and must be strictly implemented.
浙大中控DCS卡件
历史数据保存在操作站硬盘上,与系统停电等因素无关。历史数据是追查事故责任的重要手段。
The historical data is saved on the hard disk of the operation station, independent of factors such as system power failure. Historical data is an important means of tracing accident liability.
操作站计算机是系统的重要组成部分,须保持其正常运行和整洁。
The computer of the operation station is an important part of the system and must be kept in normal operation and tidiness.
当浙大中控DCS卡件故障时应把相应控制回路立即切回手动,并通知DCS系统维护人员立即更换故障卡件,检查确认故障消除时方可再次将系统投入自动。
When the DCS card of Zhejiang University central control system fails, the corresponding control loop shall be immediately switched back to manual mode, and the DCS system maintenance personnel shall be notified to replace the faulty card immediately. The system can be put into automatic mode again only after checking and confirming that the fault is eliminated.
中控DCS卡件系统的使用有什么注意事项?以上讲解了部分内容,更多的注意事项您可以来我们网站http://www.sdjkyqyb.com进行详细的咨询。
What are the precautions for using the central control DCS card system? Some of the above contents have been explained. You can come to our website for more precautions http://www.sdjkyqyb.com Detailed consultation.
产品推荐
新闻推荐